You need one uncut sheet of printer paper, short edge at the top. No scissors, tape or clips. Measurements are rounded to the nearest ⅛ inch, as in the app.

moves fold line where it lands Diagrams are drawn on Letter and zoom in after the fold in half; the bar in each corner is 1 inch. Tap a diagram to watch the fold.

Fold it step by step

01
Crease down the middle
Fold the sheet in half the long way, press, and unfold it.
This crease becomes the body.
02
Fold the top edge down
Fold the top edge down 1⅜ in (3.6 cm). Keep it straight across.Fold the top edge down 3.9 cm (1½ in). Keep it straight across.
Line the edges up with the sides of the page.
03
Roll it again
Fold that strip down again, the same width.
The roll stacks extra layers along the front edge.
04
And once more
One more roll. The front is now a thick, stiff strip.
Press it flat so it does not unroll.
05
Turn it over
Flip the paper so the rolled strip is underneath.
The strip should be at the top, away from you.
06
Fold the top corners in
Fold the top-right corner down so the top edge lies along the center crease.
This stacks extra layers at the front.
07
And the left corner
Same on the left: a pointed nose.
The two edges meet on the crease.
08
Fold it in half
Fold it in half along the center crease, with the strip on the outside.
Match the corners at the front edge.
09
Fold down the first wing
Fold the top layer down on a slant: 2 in (5.1 cm) from the center fold at the nose, ¾ in (1.8 cm) from it at the tail.Fold the top layer down on a slant: 5.1 cm (2 in) from the center fold at the nose, 1.8 cm (¾ in) from it at the tail.
The crease slants: farther from the center fold at the nose than at the tail. Measure both ends.
10
Turn it over
Flip the plane over.
Nose still pointing away.
11
Fold down the second wing
Fold this wing down on the same slant as the first one.
Make both wings the same width.
12
Open the wings
Open the wings until they are flat, with just a tiny upward Y. Bend the back edges up a hair.

Check the shape

From behind: this is the view to compare with your plane.

Support the rolled edge while opening the wings so the layers stay together. Watch whether a turn repeats before calling it a characteristic of the design.

Before you open the wings, hold the plane closed against a window: both wing outlines should cover each other. Fix an unequal wing crease before reaching for trim.

First flights

Launch: Hold it near the middle and let it go gently, nose slightly up.

Rolled edge. The rolled strip is the stiff front of the wing. If it starts to unroll at one end, re-press it; a loose roll changes one wing more than the other.

If it misbehaves

Dives straight down: Release level, then bend both back edges up a hair.
Climbs, then drops: Flatten those bends a little; throw nearer level.
Always turns one way: Compare the wings first. Then bend the edge on the inside of the turn down, or the outside edge up, very slightly.

Full troubleshooting guide →

The app can fly this plane in a simulator. Its distances and paths are simulation output; this page makes no claim about how far a hand-folded Vulture will fly.

More rolled leading edges

Instead of a point, the top edge is rolled down two or three times into a stiff strip. The wings stay broad, and the rolled edge becomes the front of each wing.