You need one uncut sheet of printer paper, short edge at the top. No scissors, tape or clips. Measurements are rounded to the nearest ⅛ inch, as in the app.

moves fold line where it lands Diagrams are drawn on Letter and zoom in after the fold in half; the bar in each corner is 1 inch. Tap a diagram to watch the fold.

Fold it step by step

01
Crease down the middle
Fold the sheet in half the long way, press, and open it.
This is your guide line.
02
Fold the top edge down
Fold the top edge down ⅞ in (2.2 cm). Keep it straight across.Fold the top edge down 2.4 cm (⅞ in). Keep it straight across.
Line it up with the sides of the page.
03
Roll it again
Fold that strip down once more, the same width.
The rolled strip stacks layers along the front edge.
04
Fold the top corners in
Fold the top-right corner down so the rolled edge lies along the center crease.
Fold right over the strip. It is thick, so press firmly.
05
And the left corner
Same on the left side.
The two edges meet on the crease.
06
Fold it in half
Fold in half along the crease with the flaps inside.
Press from nose to tail.
07
Fold down the first wing
Fold the top layer down on a slant: 2½ in (6.3 cm) from the center fold at the nose, 1 in (2.5 cm) from it at the tail.Fold the top layer down on a slant: 6.3 cm (2½ in) from the center fold at the nose, 2.5 cm (1 in) from it at the tail.
The crease slants: farther from the center fold at the nose than at the tail. Measure both ends.
08
Turn it over
Flip the plane over.
Nose pointing away.
09
Fold down the second wing
Fold this wing down on the same slant as the first one.
Compare the wings: an unequal pair is the usual cause of a turn.
10
Open the wings and bend one side
Open the wings into a steep Y, then bend the LEFT wing's back edge up about 3 mm and the RIGHT one down about 2 mm.

Check the shape

From behind: this is the view to compare with your plane.

Record the initial direction and how far the curve develops. A return to the starting area is an observation to test, not a promised outcome.

The different back-edge bends are intentional for this stunt. Unequal wing creases are still a folding error; fix those first.

First flights

Launch:

The trim is the stunt. The last step sets it: Open the wings into a steep Y, then bend the LEFT wing's back edge up about 3 mm and the RIGHT one down about 2 mm.

The unequal bends make it curve. Throw in a large clear space and note which way it turns and how tight the curve is; a return to your hand is something to test for, not a promise. To curve the other way, swap the bends.

Rolled edge. The rolled strip is the stiff front of the wing. If it starts to unroll at one end, re-press it; a loose roll changes one wing more than the other.

If it misbehaves

Dives straight down: Release level, then bend both back edges up a hair.
Climbs, then drops: Flatten those bends a little; throw nearer level.
Always turns one way: Compare the wings first. Then bend the edge on the inside of the turn down, or the outside edge up, very slightly.

Full troubleshooting guide →

The app can fly this plane in a simulator. Its distances and paths are simulation output; this page makes no claim about how far a hand-folded Orbit will fly.

More rolled leading edges

Instead of a point, the top edge is rolled down two or three times into a stiff strip. The wings stay broad, and the rolled edge becomes the front of each wing.