You need one uncut sheet of printer paper, short edge at the top. No scissors, tape or clips. Measurements are rounded to the nearest ⅛ inch, as in the app.

moves fold line where it lands Diagrams are drawn on Letter and zoom in after the fold in half; the bar in each corner is 1 inch. Tap a diagram to watch the fold.

Fold it step by step

01
Crease down the middle
Fold the sheet in half the long way. Press a sharp crease, then open it flat again.
Run your thumbnail along every crease. Sharp creases hold their shape.
02
Fold the top corners in
Bring the top-right corner down so the top edge lies right along the center crease.
Line the edge up first, then press the fold flat.
03
Now the left corner
Same thing on the left side. Now the top looks like a pointy roof.
Both sides should meet exactly on the crease.
04
Fold the edges in again
Fold the new slanted right edge in to the center crease. The nose gets sharper.
Keep the point crisp; a slightly rounded tip is fine.
05
Match it on the left
Fold the slanted left edge in to the center too.
Check the two sides are mirror images.
06
Fold it in half
Fold the plane in half along the center crease, with all the flaps on the inside.
Press from the nose toward the tail.
07
Fold down the first wing
Fold the top layer down along a line 1 in (2.7 cm) up from the center fold, parallel to it.Fold the top layer down along a line 2.7 cm (1 in) up from the center fold, parallel to it.
This leaves a small body underneath to hold on to.
08
Turn it over
Flip the plane over so the other side faces up.
Keep the nose pointing the same way.
09
Fold down the second wing
Fold this wing down to match the first one exactly.
Hold the two wings together to check they line up.
10
Open the wings and bend the tail up
Open the wings, then bend the back edge of each wing up about 2 mm, the thickness of two coins.

Check the shape

From behind: this is the view to compare with your plane.

Observe whether the plane completes a curved path or simply climbs and stalls. A single upward arc is not evidence of a completed loop.

The different back-edge bends are intentional for this stunt. Unequal wing creases are still a folding error; fix those first.

First flights

Launch: Throw firmly, aiming well above level.

The trim is the stunt. The last step sets it: Open the wings, then bend the back edge of each wing up about 2 mm, the thickness of two coins.

Loops need height and room. Throw upward in an open space, and watch the whole path: a climb that ends in a nose-down drop is a stall, not a loop. If it stalls, check that the two bends match before making them bigger.

If it misbehaves

Dives straight down: Release level, then bend both back edges up a hair.
Climbs, then drops: Flatten those bends a little; throw nearer level.
Always turns one way: Compare the wings first. Then bend the edge on the inside of the turn down, or the outside edge up, very slightly.

Full troubleshooting guide →

The app can fly this plane in a simulator. Its distances and paths are simulation output; this page makes no claim about how far a hand-folded Loop-de-Loop will fly.

More pointed darts

Two pairs of diagonal folds stack the layers into a sharp nose. It is the sequence most people already half-know, which makes it the easiest place to learn symmetry, and the stunt setups start from this body too.